It doesn’t matter if it’s for your personal safety, for roadworthiness testing or to avoid a fine, being sure your headlamp bulbs are always working is necessary. In reality, bulbs are wearing units that will obviously burn out after a while and consequently need to be swapped out. You’re most certainly on the website because one of your parking lights is burnt out and you’re worried about how to change your Volvo V50’s license plate bulb, we’ve created this content page to help you do it all on your own and not have to go to your auto mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Volvo V50.

change-license-plate-bulb-volvo-v50

How to change the license plate bulb on your Volvo V50 throughout the outside

This process is the simplest of the two, in reality, for this one you will just have to take away the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the case we will spend a moment on in the second section of this content page to teach you the approach.
So let’s begin with replacing the number plate bulb by going through the outside of your Volvo V50. It doesn’t matter if it’s the front or the back of your car the operation will be similar.
Here are a few simple guidelines to stick to to carry out this maintenance:

  • With the engine off, disconnect the battery terminals from your car
  • Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this purpose (commonly on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Volvo V50
  • .

  • Use your screwdriver or knife to eject the bulb from its spot, if you are worried of destroying something, you can as well do it with your fingers.
  • Finally, put the new license plate light bulb
  • Last stage, before reassembling, reconnect your battery and check the light to validate the success of the operation.

How to replace the number plate bulb on your Volvo V50 without outside access

Second section of our item, change this license plate bulb on your Volvo V50 without external access. In most cases you will be able to access it, nevertheless some series (often at the rear does not allow this access).

How to change the front license plate bulb on my Volvo V50

To change the one on the front plate, nothing could be easier, you will have to put yourself under the car (ideally positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, commonly held by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Remove the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to exert too much force or you will break the plastic cover), and you will just have to take away the burnt-out license plate bulb and swap it with the new , then test and reassemble the whole thing.

How to change the rear license plate bulb on my Volvo V50

Finally last solution, you must change the bulb on the backplate of your Volvo V50, but you cannot open the cover from the outside of your car. In this case, here is the method to accomplish this task:

  • Disconnect the battery from your Volvo V50
  • Find the position of your light bulbs from the outside.
  • From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
  • Once found, before removing the bulb holders, disconnect the holders for less complicated access.
  • Using a screwdriver, lever the two plastic parts to remove the bulb holder
  • .

  • Change the burnt-out license plate bulb on your Volvo V50, check it and reassemble it, watching the clips on the trunk liner

.
There you have it, you have learned the main methods for replacing license plate bulbs on your car, take notice that on some models the technique may be a bit different but you should be able to do it following the explanation of this content page. If you can’t do it, don’t be reluctant to go to your workshop it would be a shame to break a part of your Volvo V50. If you need to change other bulbs like the position light bulbs on your Volvo V50 or the low beam bulbs on Volvo V50, don’t be reluctant to read our content articles which demonstrate you the process to follow.

If you have any additional questions about the Volvo V50, do not hesitate to consult our Volvo V50 category.