Regardless whether it’s for your personal safety, for roadworthiness testing or to avoid a fine, being certain your headlamp bulbs are constantly functional is extremely important. In reality, bulbs are wearing units that will undoubtedly burn out in the future and therefore need to be swapped out. You’re almost certainly on the website because one of your parking lights is burnt out and you’re wanting to know how to change your Volkswagen Scirocco’s license plate bulb, we’ve made this article to help you do it without any help and not have to go to your technician. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Volkswagen Scirocco.
How to change the license plate bulb on your Volkswagen Scirocco through the outside
This process is the least difficult of the two, in reality, for this one you will simply have to take away the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the situation we will spend some time on in the second section of this content page to show you the method.
So let’s start with changing the number plate bulb by going through the outside of your Volkswagen Scirocco. Regardless whether it’s the front or the back of your motor vehicle the procedure will be identical.
Here are a few simple steps to follow to perform this service:
- With the engine turned off, unplug the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch specified for this goal (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Volkswagen Scirocco
- Use your screwdriver or knife to remove the bulb from its location, in the event you are scared of damaging a thing, you can as well do it with your fingers.
- Finally, put the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to confirm the successfulness of the procedure.
.
How to replace the number plate bulb on your Volkswagen Scirocco without outside access
Second section of our document, change this license plate bulb on your Volkswagen Scirocco without external access. In most cases you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Volkswagen Scirocco
To change the one on the front plate, nothing could be much easier, you will have to put yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always held by two soft plastic tabs by pressing on both simultaneously, then now that you have your license plate bulb block in hand, Take off the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to apply too much force otherwise you will break the plastic cover), and you will just have to take away the burnt-out license plate bulb and swap it with the new , then test out and reassemble the whole thing.
How to change the rear license plate bulb on my Volkswagen Scirocco
Finally last option, you must change the bulb on the backplate of your Volkswagen Scirocco, but you cannot really open the cover from the outside of your motor vehicle. In this case, here is the solution to perform this task:
- Unplug the battery from your Volkswagen Scirocco
- Locate the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever delicately on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, unplug the holders for easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Volkswagen Scirocco, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have found out the main ways for changing license plate bulbs on your car, be aware that on some models the technique may be a bit different but you should be able to realize it following the outline of this content page. If you can’t do it, don’t be reluctant to go to your garage it would be a shame to break a part of your Volkswagen Scirocco. If you want to change other bulbs like the position light bulbs on your Volkswagen Scirocco or the low beam bulbs on Volkswagen Scirocco, don’t be reluctant to consult our articles which explain you the process to follow.
If perhaps you have any additional questions about the Volkswagen Scirocco, do not hesitate to consult our Volkswagen Scirocco category.
