It doesn’t matter if it’s for your personal security, for roadworthiness testing or to avoid a fine, being sure your headlamp bulbs are always operational is very important. In fact, bulbs are wearing auto parts that will inevitably burn out after a while and as a consequence need to be changed. You’re perhaps in this article because one of your parking lights is burnt out and you’re questioning how to change your Volkswagen Golf 6’s license plate bulb, we’ve written this document to help you do it all on your own and not have to go to your auto mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Volkswagen Golf 6.
How to change the license plate bulb on your Volkswagen Golf 6 coming from the outside
This technique is the most simple of the two, actually, for this one you will just have to take away the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will take a moment on in the second part of this article content to clarify the way.
So let’s start with changing the number plate bulb by going through the outside of your Volkswagen Golf 6. It doesn’t matter if it’s the front or the back of your vehicle the technique will be identical.
Here are a few simple steps to stick to to carry out this routine service:
- With the engine turned off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch provided for this intent (in most cases on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Volkswagen Golf 6
- Use your screwdriver or knife to remove the bulb from its spot, in the event that you are afraid of breaking a thing, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and test the light to validate the success of the operation.
.
How to replace the number plate bulb on your Volkswagen Golf 6 without outside access
Second part of our item, replace this license plate bulb on your Volkswagen Golf 6 without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Volkswagen Golf 6
To change the one on the front plate, nothing could be less difficult, you will have to position yourself under the vehicle (ideally placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in most cases held by two soft plastic tabs by pressing on both at the same time, then once you have your license plate bulb block in hand, Take out the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be mindful not to apply too much pressure or you will break the plastic cover), and you will just have to take away the burnt-out license plate bulb and change it with the new , then test and reassemble the whole thing.
How to change the rear license plate bulb on my Volkswagen Golf 6
Finally last possibility, you must change the bulb on the backplate of your Volkswagen Golf 6, but you are not able to open the cover from the outside of your vehicle. In this case, here is the solution to execute this operation:
- Unplug the battery from your Volkswagen Golf 6
- Identify the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Volkswagen Golf 6, test it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have learned the main tactics for changing license plate bulbs on your car, be aware that on some models the technique may be a bit different but you should be able to realize it following the outline of this document. If you can’t do it, don’t hesitate to go to your garage it would be a shame to break a part of your Volkswagen Golf 6. If you want to change other bulbs like the position light bulbs on your Volkswagen Golf 6 or the low beam bulbs on Volkswagen Golf 6, don’t hesitate to read our articles which describe you the operation to follow.
To find more tips on the Volkswagen Golf 6, take a look at the Volkswagen Golf 6 category.
