Regardless whether it’s for your own security, for roadworthiness testing or to avoid a fine, making sure your headlamp bulbs are all the time functioning is extremely important. In reality, bulbs are wearing units that will predictably burn out as time passes and consequently need to be swapped out. You’re quite likely in this article because one of your parking lights is burnt out and you’re struggling with how to change your Toyota Avensis’s license plate bulb, we’ve written and published this content page to help you do it without any help and not have to go to your auto technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Toyota Avensis.
How to replace the license plate bulb on your Toyota Avensis throughout the outside
This method is the least difficult of the two, in reality, for this one you will only require to take out the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will take some time on in the second part of this article content to teach you the approach.
So let’s begin with changing the number plate bulb by going through the outside of your Toyota Avensis. Regardless whether it’s the front or the back of your automobile the process will be the same.
Here are a few simple guidelines to stick to to execute this routine service:
- With the engine turned off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch assigned for this goal (in most cases on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Toyota Avensis
- Use your screwdriver or knife to eject the bulb from its location, if you are afraid of breaking anything, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to confirm the success of the task.
.
How to replace the number plate bulb on your Toyota Avensis without outside access
Second part of our content page, swap this license plate bulb on your Toyota Avensis without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to replace the front license plate bulb on my Toyota Avensis
To replace the one on the front plate, nothing could be much easier, you will have to position yourself under the automobile (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in most cases held by two soft plastic tabs by pressing on both at the same time, then once you have your license plate bulb block in hand, Remove the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to put in too much pressure otherwise you will break the plastic cover), and you will just have to take out the burnt-out license plate bulb and change it with the new , then test out and reassemble the whole thing.
How to replace the rear license plate bulb on my Toyota Avensis
Finally last possibility, you must replace the bulb on the backplate of your Toyota Avensis, but you cannot really open the cover from the outside of your automobile. In this instance, here is the process to perform this task:
- Disconnect the battery from your Toyota Avensis
- Locate the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once found, before removing the bulb holders, disconnect the holders for less difficult access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Toyota Avensis, check it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have found out the main techniques for changing license plate bulbs on your car, take notice that on some models the technique may be a bit different but you should be able to do it following the outline of this article content. If you can’t do it, don’t be reluctant to go to your workshop it would be a shame to break a part of your Toyota Avensis. If you wish to change other bulbs like the position light bulbs on your Toyota Avensis or the low beam bulbs on Toyota Avensis, don’t be reluctant to read our articles which demonstrate you the procedure to follow.
To discover more tips on the Toyota Avensis, take a look at the Toyota Avensis category.
