Regardless whether it’s for your own safety, for roadworthiness tests or to avoid a fine, ensuring that your headlamp bulbs are always working is fundamental. Indeed, bulbs are wearing auto parts that will undoubtedly burn out over time and consequently need to be replaced. You’re probably on this site because one of your parking lights is burnt out and you’re worried about how to change your Suzuki Jimny’s license plate bulb, we’ve created this document to help you do it all on your own and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Suzuki Jimny.
How to swap the license plate bulb on your Suzuki Jimny through the outside
This solution is the fastest of the two, in truth, for this one you will just need to remove the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the case we will take some time on in the second part of this document to teach you the method.
So let’s begin with swapping the number plate bulb by going through the outside of your Suzuki Jimny. Regardless whether it’s the front or the back of your motor vehicle the method will be similar.
Here are a few simple guidelines to follow to conduct this routine service:
- With the engine turned off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this intent (usually on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Suzuki Jimny
- Use your screwdriver or knife to eject the bulb from its place, in the event you are afraid of damaging a thing, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to confirm the success of the operation.
.
How to replace the number plate bulb on your Suzuki Jimny without outside access
Second part of our document, replace this license plate bulb on your Suzuki Jimny without external access. Most often you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Suzuki Jimny
To swap the one on the front plate, nothing could be easier, you will have to position yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, usually held by two soft plastic tabs by pressing on both at the same time, then right after you have your license plate bulb block in hand, Remove the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to apply too much force or you will break the plastic cover), and you will only have to remove the burnt-out license plate bulb and change it with the new , then test out and reassemble the whole thing.
How to swap the rear license plate bulb on my Suzuki Jimny
Finally last possibility, you must swap the bulb on the backplate of your Suzuki Jimny, but you simply cannot open the cover from the outside of your motor vehicle. In this case, here is the process to operate this task:
- Disconnect the battery from your Suzuki Jimny
- Find the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Suzuki Jimny, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main techniques for swapping license plate bulbs on your car, take note that on some models the technique may be a bit different but you should be able to accomplish it following the outline of this document. If you can’t do it, don’t be reluctant to go to your garage it would be a shame to break a part of your Suzuki Jimny. If you need to change other bulbs like the position light bulbs on your Suzuki Jimny or the low beam bulbs on Suzuki Jimny, don’t be reluctant to browse our content articles which describe you the operation to follow.
To get more tips on the Suzuki Jimny, take a look at the Suzuki Jimny category.
