It doesn’t matter if it’s for your personal security, for roadworthiness testing or to avoid a fine, ensuring that your headlamp bulbs are always operational is fundamental. In fact, bulbs are wearing units that will surely burn out as time passes and consequently need to be swapped out. You’re almost certainly here because one of your parking lights is burnt out and you’re wondering how to change your Suzuki Across’s license plate bulb, we’ve written and published this document to help you do it by yourself and not have to go to your mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Suzuki Across.

change-license-plate-bulb-suzuki-across

How to replace the license plate bulb on your Suzuki Across throughout the outside

This process is the simplest of the two, in truth, for this one you will simply need to remove the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the case we will take a moment on in the second section of this content to demonstrate the way.
So let’s start with changing the number plate bulb by going through the outside of your Suzuki Across. It doesn’t matter if it’s the front or the back of your motor vehicle the technique will be the same.
Here are a few simple guidelines to stick to to conduct this maintenance tasks:

  • With the engine turned off, unplug the battery terminals from your car
  • Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch assigned for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Suzuki Across
  • .

  • Use your screwdriver or knife to remove the bulb from its placement, in the event that you are scared of damaging a thing, you can as well do it with your fingers.
  • Finally, put the new license plate light bulb
  • Last stage, before reassembling, reconnect your battery and check the light to confirm the success of the task.

How to change the number plate bulb on your Suzuki Across without outside access

Second section of our content page, change this license plate bulb on your Suzuki Across without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).

How to replace the front license plate bulb on my Suzuki Across

To replace the one on the front plate, nothing could be easier, you will have to put yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Remove the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be mindful not to apply too much pressure or you will break the plastic cover), and you will only have to remove the burnt-out license plate bulb and replace it with the new , then test and reassemble the whole thing.

How to replace the rear license plate bulb on my Suzuki Across

Finally last option, you must replace the bulb on the backplate of your Suzuki Across, but you cannot open the cover from the outside of your motor vehicle. In such a case, here is the tactic to perform this operation:

  • Disconnect the battery from your Suzuki Across
  • Identify the location of your light bulbs from the outside.
  • From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
  • Once located, before removing the bulb holders, unplug the holders for less difficult access.
  • Using a screwdriver, lever the two plastic parts to remove the bulb holder
  • .

  • Replace the burnt-out license plate bulb on your Suzuki Across, check it and reassemble it, watching the clips on the trunk liner

.
There you have it, you have discovered the main solutions for changing license plate bulbs on your car, take notice that on some models the methodology may be a bit different but you should be able to accomplish it following the explanation of this article. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Suzuki Across. If you wish to change other bulbs like the position light bulbs on your Suzuki Across or the low beam bulbs on Suzuki Across, don’t hesitate to consult our content articles which describe you the operation to follow.

If you need more guides on the Suzuki Across, go to our Suzuki Across category.