It doesn’t matter if it’s for your personal safety, for roadworthiness testing or to avoid a fine, ensuring that your headlamp bulbs are always functioning is very important. In fact, bulbs are wearing units that will surely burn out as time passes and consequently need to be changed. You’re most certainly on this website because one of your parking lights is burnt out and you’re struggling with how to change your Mercedes Benz GLK’s license plate bulb, we’ve created this article to help you do it on your own and not have to go to your auto technician. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Mercedes Benz GLK.

change-license-plate-bulb-mercedes-benz-glk

How to change the license plate bulb on your Mercedes Benz GLK through the outside

This technique is the least difficult of the two, in fact, for this one you will only need to take away the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the case we will dedicate a moment on in the second section of this content to clarify the method.
So let’s start with changing the number plate bulb by going through the outside of your Mercedes Benz GLK. It doesn’t matter if it’s the front or the back of your vehicle the method will be similar.
Here are a few simple actions to follow to execute this service:

  • With the engine off, disconnect the battery terminals from your car
  • Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch specified for this intent (commonly on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Mercedes Benz GLK
  • .

  • Use your screwdriver or knife to remove the bulb from its spot, in the event that you are afraid of destroying a thing, you can also do it with your fingers.
  • Finally, position the new license plate light bulb
  • Last stage, before reassembling, reconnect your battery and test the light to confirm the success of the operation.

How to change the number plate bulb on your Mercedes Benz GLK without outside access

Second section of our content page, swap this license plate bulb on your Mercedes Benz GLK without external access. Most often you will be able to access it, however some series (often at the rear does not allow this access).

How to change the front license plate bulb on my Mercedes Benz GLK

To change the one on the front plate, nothing could be less difficult, you will have to position yourself under the vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, commonly kept by two soft plastic tabs by pressing on both at once, then once you have your license plate bulb block in hand, Remove the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to put in too much force otherwise you will break the plastic cover), and you will only have to take away the burnt-out license plate bulb and replace it with the new , then check and reassemble the whole thing.

How to change the rear license plate bulb on my Mercedes Benz GLK

Finally last solution, you must change the bulb on the backplate of your Mercedes Benz GLK, but you cannot really open the cover from the outside of your vehicle. In such a case, here is the solution to do this task:

  • Disconnect the battery from your Mercedes Benz GLK
  • Locate the spot of your light bulbs from the outside.
  • From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever delicately on all the frame of the trunk to remove it.
  • Once located, before removing the bulb holders, disconnect the holders for less complicated access.
  • Using a screwdriver, lever the two plastic parts to remove the bulb holder
  • .

  • Replace the burnt-out license plate bulb on your Mercedes Benz GLK, test it and reassemble it, watching the clips on the trunk liner

.
There you have it, you have found out the main solutions for changing license plate bulbs on your car, remember that on some models the method may be a bit different but you should be able to do it following the outline of this article. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Mercedes Benz GLK. If you desire to change other bulbs like the position light bulbs on your Mercedes Benz GLK or the low beam bulbs on Mercedes Benz GLK, don’t hesitate to read our articles which demonstrate you the operation to follow.

If perhaps you have any further questions about the Mercedes Benz GLK, do not hesitate to consult our Mercedes Benz GLK category.