It doesn’t matter if it’s for your own security, for roadworthiness tests or to avoid a fine, being sure your headlamp bulbs are all the time operational is very important. In fact, bulbs are wearing auto parts that will undoubtedly burn out over the years and consequently need to be replaced. You’re perhaps here because one of your parking lights is burnt out and you’re questioning how to change your Jaguar F-Pace’s license plate bulb, we’ve created this content page to help you do it all on your own and not have to go to your auto technician. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Jaguar F-Pace.
How to change the license plate bulb on your Jaguar F-Pace coming from the outside
This solution is the fastest of the two, in fact, for this one you will simply need to take away the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the situation we will dedicate a moment on in the second section of this content to teach you the approach.
So let’s start with changing the number plate bulb by going through the outside of your Jaguar F-Pace. It doesn’t matter if it’s the front or the back of your automobile the process will be similar.
Here are a few simple guidelines to follow to carry out this routine service:
- With the engine off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to place the flat part into the notch specified for this purpose (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Jaguar F-Pace
- Use your screwdriver or knife to eject the bulb from its placement, if you are scared of damaging something, you can also do it with your fingers.
- Finally, put the new license plate light bulb
- Last step, before reassembling, reconnect your battery and test the light to confirm the successfulness of the task.
.
How to change the number plate bulb on your Jaguar F-Pace without outside access
Second section of our document, swap this license plate bulb on your Jaguar F-Pace without external access. Generally you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Jaguar F-Pace
To change the one on the front plate, nothing could be less complicated, you will have to put yourself under the automobile (ideally placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Take out the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to put in too much force otherwise you will break the plastic cover), and you will only have to take away the burnt-out license plate bulb and replace it with the new , then verify and reassemble the whole thing.
How to change the rear license plate bulb on my Jaguar F-Pace
Finally last possibility, you must change the bulb on the backplate of your Jaguar F-Pace, but you simply cannot open the cover from the outside of your automobile. In this instance, here is the solution to operate this operation:
- Disconnect the battery from your Jaguar F-Pace
- Identify the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once found, before removing the bulb holders, disconnect the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Jaguar F-Pace, test it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main methods for changing license plate bulbs on your car, bear in mind that on some models the technique may be a bit different but you should be able to realize it following the explanation of this article. If you can’t do it, don’t hesitate to go to your workshop it would be a shame to break a part of your Jaguar F-Pace. If you need to change other bulbs like the position light bulbs on your Jaguar F-Pace or the low beam bulbs on Jaguar F-Pace, don’t hesitate to consult our content articles which describe you the process to follow.
If you have any further questions about the Jaguar F-Pace, do not hesitate to consult our Jaguar F-Pace category.