Whether it’s for your own security, for roadworthiness testing or to avoid a fine, ensuring that your headlamp bulbs are always operational is very important. In fact, bulbs are wearing units that will predictably burn out over the years and consequently need to be swapped out. You’re probably here because one of your parking lights is burnt out and you’re wanting to know how to change your Ford F 450’s license plate bulb, we’ve written and published this content page to help you do it on your own and not have to go to your auto mechanic. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Ford F 450.
How to change the license plate bulb on your Ford F 450 through the outside
This technique is the most simple of the two, in reality, for this one you will simply require to remove the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the case we will take some time on in the second section of this document to describe the method.
So let’s start with swapping the number plate bulb by going through the outside of your Ford F 450. Whether it’s the front or the back of your motor vehicle the method will be identical.
Here are a few simple steps to stick to to conduct this maintenance tasks:
- With the engine turned off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch assigned for this goal (in most cases on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Ford F 450
- Use your screwdriver or knife to remove the bulb from its spot, in the event you are afraid of damaging a thing, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to confirm the success of the process.
.
How to replace the number plate bulb on your Ford F 450 without outside access
Second section of our content page, change this license plate bulb on your Ford F 450 without external access. Most often you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Ford F 450
To change the one on the front plate, nothing could be easier, you will have to position yourself under the motor vehicle (preferably put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in most cases held by two soft plastic tabs by pressing on both simultaneously, then right after you have your license plate bulb block in hand, Take out the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be mindful not to exert too much pressure otherwise you will break the plastic cover), and you will simply have to remove the burnt-out license plate bulb and replace it with the new , then verify and reassemble the whole thing.
How to change the rear license plate bulb on my Ford F 450
Finally last solution, you must change the bulb on the backplate of your Ford F 450, but you cannot open the cover from the outside of your motor vehicle. In this case, here is the technique to accomplish this operation:
- Disconnect the battery from your Ford F 450
- Find the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Ford F 450, check it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have discovered the main approaches for swapping license plate bulbs on your car, take notice that on some models the technique may be a bit different but you should be able to realize it following the outline of this content. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Ford F 450. If you desire to change other bulbs like the position light bulbs on your Ford F 450 or the low beam bulbs on Ford F 450, don’t hesitate to browse our articles which explain you the operation to follow.
If you want more guides on the Ford F 450, go to our Ford F 450 category.
