Regardless it’s for your specific safety, for roadworthiness testing or to avoid a fine, being sure your headlamp bulbs are all the time functional is really important. In reality, bulbs are wearing units that will obviously burn out over time and as a result need to be swapped out. You’re likely here because one of your parking lights is burnt out and you’re wondering how to change your Ford C Max’s license plate bulb, we’ve written this article to help you do it without any help and not have to go to your mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Ford C Max.
How to change the license plate bulb on your Ford C Max throughout the outside
This method is the least difficult of the two, in truth, for this one you will simply need to take off the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will spend some time on in the second part of this article to explain the approach.
So let’s begin with replacing the number plate bulb by going through the outside of your Ford C Max. Regardless it’s the front or the back of your motor vehicle the operation will be identical.
Here are a few simple actions to stick to to carry out this service:
- With the engine turned off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch provided for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Ford C Max
- Use your screwdriver or knife to remove the bulb from its location, if you are worried of damaging something, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to validate the achievement of the procedure.
.
How to change the number plate bulb on your Ford C Max without outside access
Second part of our article, change this license plate bulb on your Ford C Max without external access. Most often you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Ford C Max
To change the one on the front plate, nothing could be simpler, you will have to position yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general kept by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Take away the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to put in too much force otherwise you will break the plastic cover), and you will only have to take off the burnt-out license plate bulb and swap it with the new , then verify and reassemble the whole thing.
How to change the rear license plate bulb on my Ford C Max
Finally last option, you must change the bulb on the backplate of your Ford C Max, but you simply cannot open the cover from the outside of your motor vehicle. In such a case, here is the technique to operate this operation:
- Disconnect the battery from your Ford C Max
- Find the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Ford C Max, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have found out the main ways for replacing license plate bulbs on your car, take note that on some models the method may be a bit different but you should be able to realize it following the outline of this content. If you can’t do it, don’t be reluctant to go to your mechanic it would be a shame to break a part of your Ford C Max. If you wish to change other bulbs like the position light bulbs on your Ford C Max or the low beam bulbs on Ford C Max, don’t be reluctant to browse our content articles which describe you the operation to follow.
If perhaps you have any additional questions about the Ford C Max, do not hesitate to consult our Ford C Max category.
