Whether it’s for your specific security, for roadworthiness testing or to avoid a fine, making sure your headlamp bulbs are all the time functioning is extremely important. Indeed, bulbs are wearing units that will obviously burn out after some time and therefore need to be replaced. You’re almost certainly on this website because one of your parking lights is burnt out and you’re struggling with how to change your Ford C-max’s license plate bulb, we’ve made this content to help you do it by yourself and not have to go to your auto mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Ford C-max.
How to change the license plate bulb on your Ford C-max coming from the outside
This solution is the simplest of the two, in reality, for this one you will just have to remove the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the case we will take some time on in the second section of this article content to describe the method.
So let’s begin with replacing the number plate bulb by going through the outside of your Ford C-max. Whether it’s the front or the back of your motor vehicle the technique will be similar.
Here are a few simple steps to stick to to perform this service:
- With the engine turned off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch assigned for this intent (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Ford C-max
- Use your screwdriver or knife to eject the bulb from its placement, if you are afraid of breaking anything, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and test the light to validate the achievement of the process.
.
How to replace the number plate bulb on your Ford C-max without outside access
Second section of our content page, swap this license plate bulb on your Ford C-max without external access. Most often you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Ford C-max
To change the one on the front plate, nothing could be much easier, you will have to position yourself under the motor vehicle (ideally placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always kept by two soft plastic tabs by pressing on both at the same time, then now that you have your license plate bulb block in hand, Take off the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take extra care not to apply too much force otherwise you will break the plastic cover), and you will only have to remove the burnt-out license plate bulb and swap it with the new , then test and reassemble the whole thing.
How to change the rear license plate bulb on my Ford C-max
Finally last possibility, you must change the bulb on the backplate of your Ford C-max, but you are not able to open the cover from the outside of your motor vehicle. In this case, here is the method to execute this task:
- Unplug the battery from your Ford C-max
- Identify the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Ford C-max, test it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main methods for replacing license plate bulbs on your car, take note that on some models the method may be a bit different but you should be able to realize it following the explanation of this article. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Ford C-max. If you desire to change other bulbs like the position light bulbs on your Ford C-max or the low beam bulbs on Ford C-max, don’t hesitate to consult our content articles which demonstrate you the procedure to follow.
If you wish more guides on the Ford C-max, go to our Ford C-max category.
