Regardless whether it’s for your personal safety, for roadworthiness tests or to avoid a fine, ensuring your headlamp bulbs are always working is necessary. In reality, bulbs are wearing parts that will predictably burn out after some time and consequently need to be changed. You’re perhaps here because one of your parking lights is burnt out and you’re questioning how to change your Fiat Punto’s license plate bulb, we’ve made this content page to help you do it on your own and not have to go to your technician. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Fiat Punto.
How to swap the license plate bulb on your Fiat Punto through the outside
This option is the fastest of the two, in truth, for this one you will just need to take out the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will take some time on in the second part of this article content to demonstrate the approach.
So let’s start with changing the number plate bulb by going through the outside of your Fiat Punto. Regardless whether it’s the front or the back of your motor vehicle the operation will be the same.
Here are a few simple guidelines to follow to perform this service:
- With the engine turned off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this goal (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Fiat Punto
- Use your screwdriver or knife to remove the bulb from its location, in the event that you are worried of breaking something, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and verify the light to validate the success of the procedure.
.
How to change the number plate bulb on your Fiat Punto without outside access
Second part of our document, swap this license plate bulb on your Fiat Punto without external access. In most cases you will be able to access it, however some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Fiat Punto
To swap the one on the front plate, nothing could be less hard, you will have to position yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always held by two soft plastic tabs by pressing on both at the same time, then right after you have your license plate bulb block in hand, Take out the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to exert too much pressure otherwise you will break the plastic cover), and you will only have to take out the burnt-out license plate bulb and change it with the new , then test out and reassemble the whole thing.
How to swap the rear license plate bulb on my Fiat Punto
Finally last possibility, you must swap the bulb on the backplate of your Fiat Punto, but you cannot open the cover from the outside of your motor vehicle. In this instance, here is the approach to do this operation:
- Unplug the battery from your Fiat Punto
- Locate the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever delicately on all the frame of the trunk to remove it.
- Once found, before removing the bulb holders, disconnect the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Fiat Punto, verify it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have discovered the main tactics for changing license plate bulbs on your car, bear in mind that on some models the method may be a bit different but you should be able to realize it following the explanation of this content page. If you can’t do it, don’t hesitate to go to your garage it would be a shame to break a part of your Fiat Punto. If you want to change other bulbs like the position light bulbs on your Fiat Punto or the low beam bulbs on Fiat Punto, don’t hesitate to browse our articles which describe you the operation to follow.
To discover more tips on the Fiat Punto, take a look at the Fiat Punto category.
