It doesn’t matter if it’s for your own safety, for roadworthiness tests or to avoid a fine, being sure your headlamp bulbs are all the time effective is extremely important. Indeed, bulbs are wearing auto parts that will undoubtedly burn out with time and as a consequence need to be replaced. You’re likely in this article because one of your parking lights is burnt out and you’re worried about how to change your Fiat Ducato’s license plate bulb, we’ve made this content page to help you do it without any help and not have to go to your motor mechanic. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Fiat Ducato.
How to swap the license plate bulb on your Fiat Ducato throughout the outside
This tactic is the easiest of the two, actually, for this one you will simply have to take away the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the situation we will spend some time on in the second part of this content to clarify the approach.
So let’s begin with swapping the number plate bulb by going through the outside of your Fiat Ducato. It doesn’t matter if it’s the front or the back of your vehicle the technique will be the same.
Here are a few simple steps to stick to to carry out this maintenance:
- With the engine off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch provided for this purpose (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Fiat Ducato
- Use your screwdriver or knife to eject the bulb from its placement, if you are worried of destroying something, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and test the light to validate the successfulness of the procedure.
.
How to change the number plate bulb on your Fiat Ducato without outside access
Second part of our article, change this license plate bulb on your Fiat Ducato without external access. In most cases you will be able to access it, however some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Fiat Ducato
To swap the one on the front plate, nothing could be less difficult, you will have to position yourself under the vehicle (ideally placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general kept by two soft plastic tabs by pressing on both at the same time, then once you have your license plate bulb block in hand, Take off the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to exert too much pressure otherwise you will break the plastic cover), and you will just have to take away the burnt-out license plate bulb and replace it with the new , then check and reassemble the whole thing.
How to swap the rear license plate bulb on my Fiat Ducato
Finally last solution, you must swap the bulb on the backplate of your Fiat Ducato, but you cannot really open the cover from the outside of your vehicle. In this case, here is the process to execute this task:
- Disconnect the battery from your Fiat Ducato
- Locate the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever gently on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, unplug the holders for easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Fiat Ducato, test it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have found out the main techniques for swapping license plate bulbs on your car, take note that on some models the methodology may be a bit different but you should be able to do it following the outline of this article content. If you can’t do it, don’t be reluctant to go to your mechanic it would be a shame to break a part of your Fiat Ducato. If you need to change other bulbs like the position light bulbs on your Fiat Ducato or the low beam bulbs on Fiat Ducato, don’t be reluctant to read our content articles which demonstrate you the operation to follow.
If you have any further questions about the Fiat Ducato, do not hesitate to consult our Fiat Ducato category.
