Whether it’s for your own personal safety, for roadworthiness testing or to avoid a fine, ensuring your headlamp bulbs are all the time functioning is really important. In fact, bulbs are wearing parts that will predictably burn out in the future and consequently need to be swapped out. You’re almost certainly on this site because one of your parking lights is burnt out and you’re wanting to know how to change your Ds Ds 4’s license plate bulb, we’ve written and published this content page to help you do it without any help and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Ds Ds 4.
How to swap the license plate bulb on your Ds Ds 4 throughout the outside
This method is the easiest of the two, in truth, for this one you will simply need to take out the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the case we will spend some time on in the second section of this content page to explain the approach.
So let’s begin with changing the number plate bulb by going through the outside of your Ds Ds 4. Whether it’s the front or the back of your automobile the process will be similar.
Here are a few simple guidelines to stick to to conduct this maintenance tasks:
- With the engine off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch provided for this intent (generally on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Ds Ds 4
- Use your screwdriver or knife to remove the bulb from its placement, in the event that you are afraid of breaking a thing, you can also do it with your fingers.
- Finally, put the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to validate the success of the procedure.
.
How to replace the number plate bulb on your Ds Ds 4 without outside access
Second section of our content, swap this license plate bulb on your Ds Ds 4 without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Ds Ds 4
To swap the one on the front plate, nothing could be less hard, you will have to put yourself under the automobile (preferably positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, generally kept by two soft plastic tabs by pressing on both simultaneously, then right after you have your license plate bulb block in hand, Take out the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to put in too much pressure otherwise you will break the plastic cover), and you will just have to take out the burnt-out license plate bulb and swap it with the new , then test out and reassemble the whole thing.
How to swap the rear license plate bulb on my Ds Ds 4
Finally last solution, you must swap the bulb on the backplate of your Ds Ds 4, but you cannot open the cover from the outside of your automobile. In this instance, here is the method to operate this operation:
- Unplug the battery from your Ds Ds 4
- Locate the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever delicately on all the frame of the trunk to remove it.
- Once found, before removing the bulb holders, unplug the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Ds Ds 4, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main methods for changing license plate bulbs on your car, take note that on some models the technique may be a bit different but you should be able to realize it following the outline of this article. If you can’t do it, don’t be reluctant to go to your garage area it would be a shame to break a part of your Ds Ds 4. If you need to change other bulbs like the position light bulbs on your Ds Ds 4 or the low beam bulbs on Ds Ds 4, don’t be reluctant to read our content articles which describe you the operation to follow.
To get more tips on the Ds Ds 4, take a look at the Ds Ds 4 category.
