It doesn’t matter if it’s for your personal safety, for roadworthiness testing or to avoid a fine, making sure your headlamp bulbs are constantly operational is very important. Indeed, bulbs are wearing units that will inevitably burn out with time and therefore need to be replaced. You’re most certainly on this website because one of your parking lights is burnt out and you’re wondering how to change your Dacia Sandero’s license plate bulb, we’ve created this article to help you do it all on your own and not have to go to your motor mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Dacia Sandero.
How to change the license plate bulb on your Dacia Sandero throughout the outside
This process is the easiest of the two, in reality, for this one you will simply require to take out the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the case we will take a moment on in the second section of this article to describe the way.
So let’s begin with swapping the number plate bulb by going through the outside of your Dacia Sandero. It doesn’t matter if it’s the front or the back of your car the method will be identical.
Here are a few simple actions to stick to to perform this routine service:
- With the engine off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch assigned for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Dacia Sandero
- Use your screwdriver or knife to remove the bulb from its location, if you are scared of damaging a thing, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to validate the achievement of the process.
.
How to replace the number plate bulb on your Dacia Sandero without outside access
Second section of our content page, swap this license plate bulb on your Dacia Sandero without external access. Most often you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Dacia Sandero
To change the one on the front plate, nothing could be less difficult, you will have to position yourself under the car (preferably put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Take away the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to put in too much force or you will break the plastic cover), and you will simply have to take out the burnt-out license plate bulb and swap it with the new , then test and reassemble the whole thing.
How to change the rear license plate bulb on my Dacia Sandero
Finally last option, you must change the bulb on the backplate of your Dacia Sandero, but you are not able to open the cover from the outside of your car. In such a case, here is the technique to operate this task:
- Unplug the battery from your Dacia Sandero
- Locate the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, disconnect the holders for easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Dacia Sandero, verify it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have found out the main techniques for swapping license plate bulbs on your car, remember that on some models the technique may be a bit different but you should be able to accomplish it following the outline of this content. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Dacia Sandero. If you need to change other bulbs like the position light bulbs on your Dacia Sandero or the low beam bulbs on Dacia Sandero, don’t hesitate to browse our content articles which demonstrate you the procedure to follow.
In the event that you have any further questions about the Dacia Sandero, do not hesitate to consult our Dacia Sandero category.
