Regardless it’s for your personal security, for roadworthiness tests or to avoid a fine, being certain your headlamp bulbs are constantly functional is very important. In fact, bulbs are wearing parts that will obviously burn out after some time and consequently need to be replaced. You’re probably here because one of your parking lights is burnt out and you’re wondering how to change your Chevrolet Cruze’s license plate bulb, we’ve made this content page to help you do it by yourself and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Chevrolet Cruze.
How to swap the license plate bulb on your Chevrolet Cruze through the outside
This method is the easiest of the two, actually, for this one you will just require to take out the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will take a moment on in the second part of this article to demonstrate the way.
So let’s begin with swapping the number plate bulb by going through the outside of your Chevrolet Cruze. Regardless it’s the front or the back of your automobile the technique will be identical.
Here are a few simple steps to stick to to conduct this routine service:
- With the engine off, unplug the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this purpose (generally on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Chevrolet Cruze
- Use your screwdriver or knife to remove the bulb from its spot, if you are afraid of breaking a thing, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to validate the success of the process.
.
How to replace the number plate bulb on your Chevrolet Cruze without outside access
Second part of our document, change this license plate bulb on your Chevrolet Cruze without external access. Generally you will be able to access it, but some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Chevrolet Cruze
To swap the one on the front plate, nothing could be simpler, you will have to position yourself under the automobile (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, generally held by two soft plastic tabs by pressing on both at once, then now that you have your license plate bulb block in hand, Take out the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to apply too much pressure otherwise you will break the plastic cover), and you will simply have to take out the burnt-out license plate bulb and change it with the new , then verify and reassemble the whole thing.
How to swap the rear license plate bulb on my Chevrolet Cruze
Finally last solution, you must swap the bulb on the backplate of your Chevrolet Cruze, but you cannot really open the cover from the outside of your automobile. In this case, here is the process to perform this operation:
- Disconnect the battery from your Chevrolet Cruze
- Locate the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, unplug the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Chevrolet Cruze, verify it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have discovered the main techniques for swapping license plate bulbs on your car, take note that on some models the technique may be a bit different but you should be able to do it following the outline of this article content. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your Chevrolet Cruze. If you wish to change other bulbs like the position light bulbs on your Chevrolet Cruze or the low beam bulbs on Chevrolet Cruze, don’t hesitate to browse our articles which describe you the operation to follow.
If perhaps you have any further questions about the Chevrolet Cruze, do not hesitate to consult our Chevrolet Cruze category.
