Whether it’s for your own safety, for roadworthiness testing or to avoid a fine, making sure your headlamp bulbs are constantly effective is fundamental. In fact, bulbs are wearing auto parts that will undoubtedly burn out after some time and consequently need to be changed. You’re most likely on this website because one of your parking lights is burnt out and you’re questioning how to change your BMW X3’s license plate bulb, we’ve written and published this content page to help you do it on your own and not have to go to your motor mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your BMW X3.
How to replace the license plate bulb on your BMW X3 throughout the outside
This tactic is the fastest of the two, in truth, for this one you will simply have to take out the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the case we will dedicate a moment on in the second part of this content to demonstrate the method.
So let’s begin with swapping the number plate bulb by going through the outside of your BMW X3. Whether it’s the front or the back of your motor vehicle the process will be identical.
Here are a few simple actions to stick to to conduct this routine service:
- With the engine off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch supplied for this intent (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your BMW X3
- Use your screwdriver or knife to remove the bulb from its placement, in the event you are afraid of breaking something, you can as well do it with your fingers.
- Finally, put the new license plate light bulb
- Last step, before reassembling, reconnect your battery and check the light to confirm the achievement of the procedure.
.
How to replace the number plate bulb on your BMW X3 without outside access
Second part of our document, swap this license plate bulb on your BMW X3 without external access. Most often you will be able to access it, but some series (often at the rear does not allow this access).
How to replace the front license plate bulb on my BMW X3
To replace the one on the front plate, nothing could be less difficult, you will have to put yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always kept by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Take away the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to put in too much pressure or you will break the plastic cover), and you will just have to take out the burnt-out license plate bulb and replace it with the new , then verify and reassemble the whole thing.
How to replace the rear license plate bulb on my BMW X3
Finally last solution, you must replace the bulb on the backplate of your BMW X3, but you cannot open the cover from the outside of your motor vehicle. In this case, here is the technique to carry out this task:
- Disconnect the battery from your BMW X3
- Locate the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your BMW X3, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main tactics for swapping license plate bulbs on your car, remember that on some models the methodology may be a bit different but you should be able to realize it following the outline of this content page. If you can’t do it, don’t be reluctant to go to your workshop it would be a shame to break a part of your BMW X3. If you desire to change other bulbs like the position light bulbs on your BMW X3 or the low beam bulbs on BMW X3, don’t be reluctant to browse our articles which describe you the process to follow.
If you wish more tutorials on the BMW X3, go to our BMW X3 category.
