Whether it’s for your own safety, for roadworthiness tests or to avoid a fine, being sure your headlamp bulbs are constantly functioning is extremely important. In fact, bulbs are wearing units that will surely burn out with time and therefore need to be replaced. You’re probably on this site because one of your parking lights is burnt out and you’re wanting to know how to change your Audi Sq7’s license plate bulb, we’ve made this article content to help you do it by yourself and not have to go to your motor mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Audi Sq7.
How to change the license plate bulb on your Audi Sq7 through the outside
This technique is the quickest of the two, in truth, for this one you will simply need to take out the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will dedicate some time on in the second section of this content page to describe the method.
So let’s begin with swapping the number plate bulb by going through the outside of your Audi Sq7. Whether it’s the front or the back of your car the process will be the same.
Here are a few simple guidelines to stick to to execute this routine service:
- With the engine off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch supplied for this intent (commonly on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Audi Sq7
- Use your screwdriver or knife to eject the bulb from its spot, in the event that you are worried of breaking anything, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and verify the light to confirm the achievement of the task.
.
How to replace the number plate bulb on your Audi Sq7 without outside access
Second section of our document, replace this license plate bulb on your Audi Sq7 without external access. Most often you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Audi Sq7
To change the one on the front plate, nothing could be less difficult, you will have to position yourself under the car (ideally placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, commonly kept by two soft plastic tabs by pressing on both simultaneously, then now that you have your license plate bulb block in hand, Take off the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take care not to put in too much force or you will break the plastic cover), and you will only have to take out the burnt-out license plate bulb and replace it with the new , then check and reassemble the whole thing.
How to change the rear license plate bulb on my Audi Sq7
Finally last possibility, you must change the bulb on the backplate of your Audi Sq7, but you simply cannot open the cover from the outside of your car. In such a case, here is the method to operate this operation:
- Disconnect the battery from your Audi Sq7
- Identify the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, unplug the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Audi Sq7, verify it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have discovered the main ways for swapping license plate bulbs on your car, remember that on some models the methodology may be a bit different but you should be able to realize it following the explanation of this content page. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Audi Sq7. If you desire to change other bulbs like the position light bulbs on your Audi Sq7 or the low beam bulbs on Audi Sq7, don’t hesitate to read our content articles which explain you the operation to follow.
Whenever you have any additional questions about the Audi Sq7, do not hesitate to consult our Audi Sq7 category.
