Regardless whether it’s for your own security, for roadworthiness tests or to avoid a fine, being sure your headlamp bulbs are all the time functioning is necessary. Indeed, bulbs are wearing parts that will inevitably burn out after a while and therefore need to be replaced. You’re most certainly on this site because one of your parking lights is burnt out and you’re struggling with how to change your Audi Rs5’s license plate bulb, we’ve made this article content to help you do it without any help and not have to go to your motor mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Audi Rs5.
How to replace the license plate bulb on your Audi Rs5 through the outside
This approach is the quickest of the two, in truth, for this one you will just have to take off the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will spend some time on in the second section of this article content to explain the method.
So let’s start with replacing the number plate bulb by going through the outside of your Audi Rs5. Regardless whether it’s the front or the back of your car the process will be the same.
Here are a few simple guidelines to stick to to perform this maintenance tasks:
- With the engine turned off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch specified for this intent (usually on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Audi Rs5
- Use your screwdriver or knife to eject the bulb from its placement, if you are scared of damaging anything, you can as well do it with your fingers.
- Finally, put the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and test the light to validate the achievement of the procedure.
.
How to change the number plate bulb on your Audi Rs5 without outside access
Second section of our item, change this license plate bulb on your Audi Rs5 without external access. In most cases you will be able to access it, however some series (often at the rear does not allow this access).
How to replace the front license plate bulb on my Audi Rs5
To replace the one on the front plate, nothing could be less hard, you will have to put yourself under the car (preferably positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, usually held by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Take away the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take care not to apply too much force or you will break the plastic cover), and you will simply have to take off the burnt-out license plate bulb and replace it with the new , then test and reassemble the whole thing.
How to replace the rear license plate bulb on my Audi Rs5
Finally last solution, you must replace the bulb on the backplate of your Audi Rs5, but you cannot open the cover from the outside of your car. In such a case, here is the process to carry out this task:
- Disconnect the battery from your Audi Rs5
- Identify the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever delicately on all the frame of the trunk to remove it.
- Once found, before removing the bulb holders, disconnect the holders for less difficult access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Audi Rs5, test it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have discovered the main methods for replacing license plate bulbs on your car, be aware that on some models the methodology may be a bit different but you should be able to realize it following the outline of this content page. If you can’t do it, don’t hesitate to go to your workshop it would be a shame to break a part of your Audi Rs5. If you desire to change other bulbs like the position light bulbs on your Audi Rs5 or the low beam bulbs on Audi Rs5, don’t hesitate to consult our content articles which demonstrate you the operation to follow.
Whenever you have any additional questions about the Audi Rs5, do not hesitate to consult our Audi Rs5 category.
