Whether it’s for your specific safety, for roadworthiness tests or to avoid a fine, ensuring your headlamp bulbs are all the time working is fundamental. In fact, bulbs are wearing auto parts that will obviously burn out after some time and as a consequence need to be swapped out. You’re most certainly here because one of your parking lights is burnt out and you’re struggling with how to change your Audi A5’s license plate bulb, we’ve made this article to help you do it all on your own and not have to go to your technician. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Audi A5.
How to change the license plate bulb on your Audi A5 through the outside
This solution is the easiest of the two, in truth, for this one you will just need to take off the protective covers of the bulbs. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the case we will dedicate some time on in the second section of this document to describe the approach.
So let’s start with changing the number plate bulb by going through the outside of your Audi A5. Whether it’s the front or the back of your automobile the process will be similar.
Here are a few simple steps to stick to to conduct this routine service:
- With the engine off, unplug the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this goal (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Audi A5
- Use your screwdriver or knife to remove the bulb from its placement, if you are scared of destroying anything, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to validate the achievement of the process.
.
How to replace the number plate bulb on your Audi A5 without outside access
Second section of our content page, replace this license plate bulb on your Audi A5 without external access. Most often you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Audi A5
To change the one on the front plate, nothing could be less difficult, you will have to position yourself under the automobile (preferably positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at the same time, then right after you have your license plate bulb block in hand, Take away the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to exert too much force or you will break the plastic cover), and you will only have to take off the burnt-out license plate bulb and change it with the new , then test and reassemble the whole thing.
How to change the rear license plate bulb on my Audi A5
Finally last solution, you must change the bulb on the backplate of your Audi A5, but you simply cannot open the cover from the outside of your automobile. In such a case, here is the process to accomplish this operation:
- Disconnect the battery from your Audi A5
- Identify the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, unplug the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Audi A5, verify it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main ways for changing license plate bulbs on your car, be aware that on some models the technique may be a bit different but you should be able to do it following the outline of this article content. If you can’t do it, don’t hesitate to go to your garage it would be a shame to break a part of your Audi A5. If you need to change other bulbs like the position light bulbs on your Audi A5 or the low beam bulbs on Audi A5, don’t hesitate to browse our articles which demonstrate you the operation to follow.
If you have any further questions about the Audi A5, do not hesitate to consult our Audi A5 category.
