It doesn’t matter if it’s for your specific security, for roadworthiness testing or to avoid a fine, being sure your headlamp bulbs are all the time effective is really important. In reality, bulbs are wearing parts that will surely burn out with time and as a result need to be replaced. You’re perhaps here because one of your parking lights is burnt out and you’re worried about how to change your Alfa Romeo 156’s license plate bulb, we’ve written and published this content to help you do it by yourself and not have to go to your auto technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Alfa Romeo 156.
How to swap the license plate bulb on your Alfa Romeo 156 throughout the outside
This approach is the most simple of the two, in truth, for this one you will only have to take away the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will dedicate some time on in the second section of this content to show you the approach.
So let’s begin with replacing the number plate bulb by going through the outside of your Alfa Romeo 156. It doesn’t matter if it’s the front or the back of your vehicle the procedure will be identical.
Here are a few simple guidelines to stick to to perform this routine service:
- With the engine off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch provided for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Alfa Romeo 156
- Use your screwdriver or knife to eject the bulb from its place, in the event you are scared of breaking anything, you can as well do it with your fingers.
- Finally, put the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to confirm the success of the operation.
.
How to replace the number plate bulb on your Alfa Romeo 156 without outside access
Second section of our content, swap this license plate bulb on your Alfa Romeo 156 without external access. Generally you will be able to access it, but some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Alfa Romeo 156
To swap the one on the front plate, nothing could be less difficult, you will have to put yourself under the vehicle (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Remove the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take extra care not to exert too much force otherwise you will break the plastic cover), and you will simply have to take away the burnt-out license plate bulb and change it with the new , then check and reassemble the whole thing.
How to swap the rear license plate bulb on my Alfa Romeo 156
Finally last possibility, you must swap the bulb on the backplate of your Alfa Romeo 156, but you simply cannot open the cover from the outside of your vehicle. In this case, here is the approach to conduct this operation:
- Disconnect the battery from your Alfa Romeo 156
- Find the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Alfa Romeo 156, verify it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main methods for replacing license plate bulbs on your car, bear in mind that on some models the method may be a bit different but you should be able to do it following the outline of this article content. If you can’t do it, don’t be reluctant to go to your workshop it would be a shame to break a part of your Alfa Romeo 156. If you want to change other bulbs like the position light bulbs on your Alfa Romeo 156 or the low beam bulbs on Alfa Romeo 156, don’t be reluctant to consult our articles which explain you the process to follow.
If you wish more guides on the Alfa Romeo 156, go to our Alfa Romeo 156 category.
