Your car’s handbrake is actually a required security feature according to the highway code, in fact , this aims to quit your Toyota C-hr, even on the slight slope. It must be independent of the main brake system controls. It is possible that after a while the cable system of the hand brake will loosen up and you will not really pass the technical control or you may feel that it can be no longer blocking your car. To deal with these problems, we will look at how to adjust the hand brake on your Toyota C-hr . To accomplish this, first we will see the adjustment of a manual handbrake on Toyota C-hr , then, in a second step, how to adjust an automatic handbrake, and finally the price of the service performed by a professional.
Adjusting a manual handbrake on Toyota C-hr?
Therefore we start off our content with the hand brake adjustment of a Toyota C-hr in its manual version. This version performs in a simple way using a system of cable and anchoring screws that allow you to control the tension of the device and so to modify the stroke of the lever of your handbrake. To act on it you must act on these screws in order to stretch the handbrake cable of your Toyota C-hr . In any case, just before adjusting the hand brake, you must check that your rear wheels aren’t blocked throughout the adjustment. Please find below the detailed method to carry out this intervention:
- In the level of the handbrake, remove the plastic console that covers it using the torx screws and clips.
- Once performed, you should discover a trapdoor in your handbrake, open it up to see the screw and cable system.
- You will have to locate the locknuts and loosen them with a wrench tool to allow you to change the cable pressure.
- Now screw on the locking mechanism nuts about both sides, ensure that you make the same changes on both sides to hold a balanced brake, and check that the hand brake handle of your Toyota C-hr has a stroke of about three notches.
- Tighten the locknuts and test out the fastening of the wheels of your car, if it’s great you can reassemble the set, otherwise tighten up again the tightening anchoring screws until you get a great optimum setting
.
If you don’t have access to the handbrake flap of your Toyota C-hr, the adjustment will probably be exactly the same but it surely will be done by passing under your car at the level of the handbrake handle. Make sure to put your car on the stand just before any actions.
How do I adjust the automatic handbrake of my own Toyota C-hr?
Second system of handbrake adjustment about Toyota C-hr , this is an automatic handbrake, not like the manual one, this is done on the brake drums or perhaps calipers, and is also expected to adjust automatically to the wear of your brake shoes or pads. It may be that if you shortly have to get brake pads, the handbrake will suffer power, listed below are the steps to take to examine if the tension of your handbrake is the right one:
- Take note that an automatic handbrake cannot be adjusted directly because it is likely to adapt by itself to the put on of the pads or pads of your Toyota C-hr.
- You can still examine that the system is functioning effectively simply by putting the car on the stand and checking by driving under the automobile that the pads are still in good performing order.
- For drum brakes will probably be necessary to disassemble the brake systems to examine your the shoes, we all suggest you to have it done by a specialist.
- Remember to replace your pads if you need to.
What is the cost of adjusting the handbrake of Toyota C-hr by a specialist?
Finally, if you do not feel comfortable with this procedure, specifically since it worries a security component of your car, namely the adjustment of the handbrake of your Toyota C-hr , we counsel you to go to a motor mechanic who can adjust the handbrake for any about fifty local currency . If you have problems with vibrations when braking on Toyota C-hr, do not wait to consult our content which works with this issue.
If you need more guides on the Toyota C-hr, go to our Toyota C-hr category.
